The coated surface is easy to clean, abrasion-resistant, and resistant to most oils.
For optimized adhesion, pre-coat the floor with W703 – Floor Coating Primer.
Increased resistance to plasticizers is achieved with W701 – Acrylate Sealer.
For garages and other heavily trafficked floors, we recommend—instead of W700 floor paint—our W702 – 2K Epoxy Resin Coating due to its significantly higher durability.
Areas of application
W700 is ideally suited for floors made of concrete, plaster, fiber cement (Eternit), cement screed, and wood, and is perfectly applicable in storage areas, offices and commercial premises, basements, etc.
Easy application
Can be applied with brush, roller, or airless spray equipment. For convenient and even application, we recommend the WO-WE floor roller. For an optimal surface and wear layer, two coats should be applied.
Ideal for indoor use
W700 is best suited for indoor applications, as it is water-based and low-odor.
Ready-to-use coating
A major advantage is that the single-component W700 floor paint is ready for immediate use. Simply open the container, mix or shake well, and apply directly.
Economical consumption
1 liter covers approx. 5–8 m² per coat (depending on surface porosity and condition).
Wide color selection
Among the W700 color shades, you are sure to find one that suits your taste. We continuously strive to expand our palette so everyone can find a shade they like.
Unser Kundendienst ist von Montag bis Freitag von 9.00 bis 18.00 Uhr erreichbar.
Durchschnittliche Antwortzeit: 24 Stunden
Optimale Verarbeitungsbedingungen
Welches Werkzeug ist das richtige?
Wie bekommt man Werkzeug sauber?
Es kommt darauf an mit welchen Materialien Du gearbeitet hast:
Reinigung von mit Epoxidharzen verunreinigten Werkzeugen ist aber schon etwas komplizierter. Man sollte immer Kosten / Nutzen abwägen:
Warum trocknet die Farbe oder das Öl nicht?
Mögliche Gründe:
Die Oberfläche ist nach ein paar Tagen Trocknung klebrig. Was kann ich tun?
Mögliche Gründe:
Wenn die Farbe dick aufgetragen wurde oder das Restöl nicht von der Oberfläche entfernt wurde, kann das Holz klebrig bleiben.
Was zu tun:
Du kannst eine Natronlauge mit warmem Wasser verwenden oder die Oberfläche mechanisch anschleifen und danach die Farbe oder das Öl erneut auftragen.